Snapmaker J1 PTFE Guide
To make filament loading easier and reduce the drag on the filament on the Snapmaker J1 I designed this PTFE guide. It is designed for the original reverse bowden tube which has an outer diameter of ~4.4mm (instead of the more common 4mm).
It was designed with MJF in mind. But I guess SLS or SLA would also work. I like that the texture of the dyed MJF part matches the texture of the hotend assembly.
This guide requires you to either remove the lid or raise it by at least 30mm.
Snapmaker J1 PTFE Guide
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Attribution-NonCommercial (CC BY-NC) License
Read More⇒
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(0)
More by Engineer
-
-
ARPS-2 – Arduino-Compatible Robot Project Shield for Arduino UNO
1393 0 5 -
A Compact Charging Breakout Board For Waveshare ESP32-C3
1926 3 7 -
AI-driven LoRa & LLM-enabled Kiosk & Food Delivery System
1929 2 0 -
-
-
-
ESP32-C3 BLE Keyboard - Battery Powered with USB-C Charging
2108 0 1 -
