RF Amplifier Controller
Controlling RF Amplifier requires a precise timing of TR Switch, Band selections, Overheat protection, SWR protection.
The controller presented here tries to accommodate all of the required feature.
Software can be downloaded from GitHub (https://github.com/nwputra/RF-Amp-Controller)
You are free to make the PCB based on this project but not for sale.
I am just an hobbyist on Amateur Radio and shares to other fellow Amateur.
Contact me on YB1NWP page.
73
RF Amplifier Controller
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Attribution-NonCommercial (CC BY-NC) License
Read More⇒
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(1)
- Likes(0)
More by Nyoman Putra
-
3 Band HF Amplifier Controller
This is another version of HF Amplifier Controller Board.It use AVR ATMEGA8 or pin compatible (ATMEG...
-
RF Amplifier Controller
Controlling RF Amplifier requires a precise timing of TR Switch, Band selections, Overheat protectio...
-
Programmable Solid State Current Limiter
This device will allow programmable limit of current to the load. With component values as in schema...
-
RF Directional Coupler
RF Directional Coupler using PCB as coupling.Bottom layer is just a ground plane.The design is then ...
-
-
ARPS-2 – Arduino-Compatible Robot Project Shield for Arduino UNO
1340 0 4 -
A Compact Charging Breakout Board For Waveshare ESP32-C3
1868 3 7 -
AI-driven LoRa & LLM-enabled Kiosk & Food Delivery System
1862 2 0 -
-
-
-
ESP32-C3 BLE Keyboard - Battery Powered with USB-C Charging
2039 0 1 -
