|
|
FE1.1S |
x 1 | |
|
|
FT232RL |
x 4 | |
|
|
Crystal 12mHz |
x 1 | |
|
|
MCP1700T 3.3V - MCP1700T-3302E/TT |
x 4 | |
|
|
MCP1700T 1.8V - MCP1700T-1802E/TT |
x 4 | |
|
|
Capacitor 10uF/16V 0805 |
x 7 | |
|
|
Capacitor 100nF/16V 0805 |
x 23 | |
|
|
Resistor 100k 0805 |
x 1 | |
|
|
Resistor 2k7 0805 |
x 1 | |
|
|
Resistor 47k 0805 |
x 1 | |
|
|
Resistor 300ohm 0805 |
x 2 | |
|
|
Resistor 150ohm 0805 |
x 9 | |
|
|
LED 0805 Blue |
x 1 | |
|
|
LED 0805 RED |
x 4 | |
|
|
LED 0805 Green |
x 4 | |
|
|
LED 0805 Yellow |
x 4 | |
|
|
Jumper 2.54mm |
x 8 | |
|
|
Signal connector 2.54mm |
x 88 |
4 port USB to UART convertor
This is 4 port USB to UART converter with chip FT232RL with USB hub FE1.1S. Logic level for FT232RL is 1.8V, 3.3V and 5V. Board have 4 separate jumper, for disable any UART channge. Using jumper is possible disconnect power supply for any channel.
It's a great extension to remove a lot of cabling from the table. All you need is one PCB, and you have 4 USB to UART converters on the table.
Schematic, PCB designe and more is on the my github repository.
4 port USB to UART convertor
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Attribution-ShareAlike (CC BY-SA) License
Read More⇒
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(1)
More by Miroslav Pivovarsky
-
-
ARPS-2 – Arduino-Compatible Robot Project Shield for Arduino UNO
1335 0 4 -
A Compact Charging Breakout Board For Waveshare ESP32-C3
1865 3 7 -
AI-driven LoRa & LLM-enabled Kiosk & Food Delivery System
1853 2 0 -
-
-
-
ESP32-C3 BLE Keyboard - Battery Powered with USB-C Charging
2032 0 1 -
