Hello!To whom it may concern, I'm interested in creating an incredibly large interactive art piece that would involve a custom made keyboard grid with LEDs that have multiple preset, and customizable ...
Why do some electronic devices that were working stop working if they remain unpowered for long periods? Is there an explanation for this and is it possible to avoid it?
In a double-layer board circuit, if the top layer is covered with GND and the bottom layer is covered with VCC, how will this copper laying method affect the circuit and is there a simulation solution...
I have these electronics tools because they are compact and portable. Are these tools good or not good for repairing retro consoles and CRT TVs?Soldering stations are expensive, take up a lot of physi...
I am trying to get a board ready for printing using PCBWay's DRC.This is my first time ever doing anything like this, I have a basic understanding only of PCB design.I have not designed this board, bu...
Hi everyone! In the last couple of days, I've been working on my very first PCB . I'm building a Morse Code Pen based on the nRF52832-QFAA.The Goal is that the device should detect button presses (Mor...
I am looking for a Wi-Fi–enabled dual-stage temperature controller. When the temperature falls below the set point, a 12 V heater along with 12 V DC Fan #1 turns ON, based on the signal received from ...
Hi everyone,I’m trying to build the **smallest possible STM32WLE5JC LoRa node** (no external LoRa module, only the integrated radio) that:- can be programmed with ST-LINK (6 pogo pads)- can send/recei...
