We designed a custom component which represents a via. The component is essentially a short steel cylinder with a hole in the middle. If we send you a PCB with this component, will you recognize this ...
What is the absolute position accuracy of pads on a single side of a PCB manufactured by PCBWay? We need to guarantee that they are positioned within ±10 μm of the specified position in the Gerbers, a...
I need to set up a differential pair of traces on a PCB for 90 ohms. I cannot find what values for epsilon I should use on the stackup page for FR4. In fact, I cannot find the epsilon value anywhere. ...
Dear reader,I am trying to design a flexible Polyamide heater through PCBway, which will be used as a thermal management system for a satellite. For a prototype we are looking for a low budget solutio...
Hello I found you via a link somewhere on another page maybe it was Reddit or quora or something. Anyways I need someone to be able to solder a little 1 in cable connector piece to my washing machines...
Is there somewhere where we get the photos that show you how to solder the wires on. I have bought the PCB previous but lost the photos when my hard drive died. I've got the software again but would l...
