PCBWay Sep 28,2018 7761

Problems Encountered in PCB Design and Their Solutions

Brief Introduction:The improvement of hardware of electronic products often takes a long time, and the major problem is often the focus of solution. But it's the small, trivial issues that ul...

PCB Design rectifier diode 1. Voltage - resistant protection electromagnetic interference pads

PCBWay Sep 14,2018 11236

ESD Inhibition Criteria in PCB Design

Introduction:Electrostatic discharge (ESD) is the sudden flow of electricity between two electrically charged objects caused by contact, an electrical short, or dielectric breakdown. A buildup of...

ESD PCB design Electrostatic discharge Charge Injection

PCBWay Mar 28,2018 8961

The depth and width of the v-cuts/grooves

Typically the depth of the v-cut is 3/4 of the thickness of the board. So if you want to do v-cuts we recommend the center of the v-cut line to any traces. Please bear this in mind when designin...